The numerical control foam cutting machine is used to complete foam cutting by wire, and the computer digitally controls two X axes and two Y axes to cut according to the predetermined track. The numerical control foam cutting machine is used to complete foam cutting by wire, and the computer digitally controls two X axes and two Y axes to cut according to the predetermined track.
Workflow of CNC foam cutting machine:
1. The numerical control foam cutting machine is combined into graphics by controlling the X axis and Y axis (resistance wire hot wire frame combined with vertical lead screw and upper and lower bearing lead screw) to run synchronously, and cutting foam products of various shapes with resistance wire. Its movement route is to use computer input graphics and automatic pulse signals to control the operation of the X and Y axes;
2. There are two methods for inputting computer product graphics: directly using computer wire cutting software to draw or using a scanning drawing board to input computer graphics;
3. Single line CNC profile cutting machine is suitable for cutting large volume or small quantity products;
4. Multi line CNC profile cutting machine is suitable for cutting small volume or large batch products. The resistance wire cutting system can use 20 resistance wires simultaneously. After inputting the graphics into the computer, all resistance wires can run in parallel and can simultaneously cut up to 20 complex two-dimensional shapes.
Compared with the traditional manual profiling cutting system, the CNC foam cutting machine has the following advantages:
1. The degree and repetition of production do not depend on the proficiency of the operators;
2. Losses caused by operator fatigue or operational errors;
3. Low labor intensity and production;
4. No need for repair or sample storage, reducing costs;
5. Computer automatically controls cutting to reduce waste;
6. Design modifications, sample production, trajectory generation, and cutting of workpieces can all be completed by one device;
7. Due to the use of a switch regulated power supply, the voltage is isolated from 220, eliminating the need for employees to use electricity.
Maintenance of CNC foam cutting machine:
1、 Daily maintenance of CNC foam cutting machine:
1. Clean the dirt on the machine tool and guide rail every working day, keep the bed clean, and turn off the air and power supply when leaving work.
If leaving the machine for a long time, the power should be turned off to prevent shutdown.
3. Pay attention to observing the lubricating oil on the horizontal and vertical guide rails and rack surfaces of the machine to maintain good lubrication!
2、 Weekly maintenance:
1. Clean the machine weekly, including the horizontal and vertical guide rails, transmission racks and small gears, and lubricate them with oil.
2. Check if the horizontal and vertical rails are working properly, and replace them promptly if there are any abnormalities.
3. Monthly and quarterly maintenance:
1. Check if the electrical cabinet, operating platform, and fastening screws are loose. Use a vacuum cleaner or hair dryer to clean the dust inside the cabinet. Check if the connector is loose.
2. Check the performance of all buttons and selection switches, replace damaged ones, and then draw a comprehensive inspection graph to check the accuracy of the machine.
The related contents of numerical control foam cutting machine are introduced.